Thermostat Or Remote Control Operation - Mendota DXV-35 DEEP TIMBER II Installation & Operating Instructions Manual

The Fireplace comes with a wall thermostat. The thermostat should be placed in the same room as the fireplace,
approx. 4-5 ft. off the floor (out of reach of children). DO NOT place thermostat within 8 feet of this fireplace
or on an outside wall.
CAUTION: BURNER SHOULD LIGHT IMMEDIATELY AFTER TURNING THERMOSTAT "ON". IF BURNER DOES NOT COME
ON IMMEDIATELY TURN THE THERMOSTAT OFF AND WAIT 60 SECONDS BEFORE TURNING ON AGAIN. IF BURNER DOES
NOT COME ON IMMEDIATELY AFTER SECOND TRY RECHECK COMPLETE INSTALLATION OF LOGS, PILOT, VENT
SYSTEM, ETC. TO INSURE PROPER PILOT FLAME IMPINGEMENT ON THE THERMOPILE, LOG AND COALS POSITIONING
AND PROMPT BURNER IGNITION. DO NOT OPERATE FIREPLACE IF BURNER DOES NOT LIGHT IMMEDIATELY. CALL
SERVICE TECHNICIAN.
NEVER TURN BURNER ON & OFF "QUICKLY" - ALWAYS WAIT 60 SECONDS!
When using remote control be sure to hold in button firmly until unit lights. DO NOT push button and release quickly
before burner lights. Burner should light IMMEDIATELY and then button can be released. If unit does not light imme-
diately release button, wait 60 seconds and repeat lighting procedure. If burner does not come on immediately after
second try recheck complete installation. If necessary, contact your Mendota dealer.
NOTE: If thermostat is located over 25 ft. from fireplace the pilot flame may need to be increased up to 750 millivolt.
CAUTION: THIS CONTROL IS A MILLIVOLT SYSTEM. NO ADDITIONAL POWER SUPPLY CAN OR SHOULD BE USED.

THERMOSTAT OR REMOTE CONTROL OPERATION

Use two-wire, copper lead wire per chart below and install as follows:
NOTE: Thermostat Must Be 460-750 Millivolt Rated
RECOMMENDED MAXIMUM
LEAD LENGTH (TWO-WIRE)
WHEN USING WALL THERMOSTAT
(CP-2 SYSTEM)
WIRE SIZE
14 GA.
16 GA.
18 GA.
20 GA.
22 GA.
Figure 11: Thermostat Wiring
NOTE: Thermostat must be 460-750 millivolt rated.
MAX. LENGTH
100 FT.
64 FT.
40 FT.
25 FT.
18 FT.
46