Dxv Door Operation - Mendota DXV-35 DEEP TIMBER II Installation & Operating Instructions Manual

1. Remove upper grill.
2. Open lower grill.
3. Place both thumbs on lower doorframe directly above Spring Loaded Door Holding Bar.
4. Reach fingers under Bar and pull Bar straight out from Fireplace front.
5. Pull Bar down and move Bar inward until Bar clears door frame - then release.
6. Repeat procedure for opposite Holding Bar.
7. Carefully lift door straight up until doorframe "clears" the 3 Door Holding Tabs on top of firebox.
8. Pull door directly out from firebox front.
1. Center door in firebox opening. Move door inward until the 3 slots on doorframe are directly above
the 3 Door Holding Tabs on firebox top.
Lower door so the 3 Tabs on firebox top fit through the 3 slots on the doorframe
2.
3. "Swing in" the lower edge of door until it touches lower firebox front.
4. Pull Holding Bar down and outward (away from Fireplace) until it clears doorframe.
5. Raise Bar until it fits securely in Bar Holding Brackets on doorframe.
6. Repeat procedure for opposite Holding Bar.
CAUTION: Holding Bars MUST be "level" and securely in place on Bar Holding Brackets holding glass door
TIGHTLY against firebox front.

DXV DOOR OPERATION

TO REMOVE DOOR
(Flat shown)
TO REPLACE DOOR
(Flat shown)
33
(i.e. "Hang" door on the 3 Tabs).