Mendota DXV-35 DEEP TIMBER II Installation & Operating Instructions Manual page 41

12. Space coals apart about ¼ inches side to side and bridge coals that span across the burner ports across the
burner tube so that the coals do not plug any burner ports. This also provides for a cove under each coal that
will glow red and create an attractive ember bed effect. If you provide large gaps between the large chunk
coals and leave the gaps open, the front burner flames will yield random yellow flames along the front edge
and between the coal pieces. Avoid packing small coals tightly. Doing so will only yield red glow effects.
Sprinkle Glowing embers over the coal and any other burner surfaces, lightly. Do not use large
and dense amounts of glowing embers in any area over burner ports. If taller flames are desired
along center burner or rear burner, add thin layers of glowing embers over burner ports in that
area. If sooting occurs around areas where coals or glowing embers are located, remove and al-
low more room in that area for gas and air to mix together properly.
40