Mendota DXV-35 DEEP TIMBER II Installation & Operating Instructions Manual page 56

Information specific to the installation of Millennia Flat Grills, Victoria Filigrees and Tuscany Filigrees
The Millennia Flat Grills, Victoria Filigree and Tuscany Fili-
gree are designed to be "inside-fit" trim kits. All of these trim
kits fit within the inner perimeter of the Fireplace's Faceplate
and remain flush within the Faceplate's front surface, see Fig-
ure below. This fitting method allows flexibility in covering
the black visible surface of the Faceplate with non-combustible
materials such as Tile, Marble, Slate, Stone and Brick; as long
as enough room is allowed for the removal of these Mendota
Designer Fronts and the glass door for servicing,
WARNING: COMBUSTIBLE MATERIALS
MUST NOT COVER THE FRONT SURFACE
OF THE FIREPLACE'S FACEPLATE.
Information specific to the installation of the
WELLINGTON FIRESCREEN FRONT:
The Wellington Fire screen Front is designed to be "in-
side-fit" trim. The top and sides of these trim kits fit with-
in the inner perimeter of the Fireplace's Faceplate. The
bottom member of this trim, however, overlaps the bottom
2" black boarder of the fireplace front faceplate. There-
fore, DO NOT COVER THE BOTTOM 2" BOARDER
OF THE FIREPLACE
INSTALLING THE WELLINGTON
TRIM. The sides and top edges of the black visible sur-
face of the Faceplate may be covered with non-
combustible materials such as Tile, Marble, Slate, Stone
and Brick; as long as enough room is allowed for the re-
moval of this Mendota Designer Fronts
and the glass door for servicing,
Hearth Protection Pad Installation Information
when planning to install the Wellington Front
If planning to install the Wellington Front, the hearth pro-
tection pad installed in front of the DXV-35 Fireplace must be designed,
built and installed so that the hearth protection pad's top surface is flush
with the bottom-most surface of the DXV35 Fireplace. See FIGURE 21.
Figure 18
FACEPLATE WHEN
FIRESCREEN
Figure 19
DO NOT COVER THIS AREA OF THE FACEPLATE WHEN
INSTALLING THE WELLINGTON FIRESCREEN FRONT
HEARTH PAD
Figure 20
55
SURFACE
HEARTH PAD SURFACE MUST BE
FLUSH WITH FIREPLACE BOTTOM
IF INSTALLING THE
WELLINGTON!!