Mendota DXV-35 DEEP TIMBER II Installation & Operating Instructions Manual page 36

2. Place Log "1" between Rear Brick Panel and rear-most burner tube – centered left to right in firebox and
butted against rear brick. Leave a ¼" gap between front surface of log #1 and rear burner tube.
3. Place Log #2 between rear-most burner and middle burner tube as shown below. Place this log so that the
pilot light notch and burner tube notches are positioned properly, as shown. The tilt angle of this log will
be fixed in subsequent steps as you install Logs #3 and #4.
35