Electro-Static Discharge Warning; Hazardous Voltage Warnings; General Safety Guidelines - Tadiran Telecom Emerald ICE Installation Manual

Electro-Static Discharge Warning

The Emerald ICE Flash Voice Mail System circuit boards are static sensitive. They
should be handled by the edges only and kept in the anti-static packaging bags until
ready for installation. Do not subject any component parts to static discharge or
physical mishandling. When handling circuit boards, it is advisable to use an anti-
static wrist strap and cover the work surface with the anti-static bag used to ship the
board. Static charges should be discharged from the body before touching the
boards or components by touching the grounded metal case of the system power
supply unit or cold water ground connection if available. The product warranty for
this equipment does not cover damage caused by such described static discharges or
mishandling. Any modules or components determined to have been damaged in
such a manner will only be replaced at dealer cost.

Hazardous Voltage Warnings

The equipment purchaser is responsible for protecting the installed equipment from
hazardous voltages. The Emerald ICE Flash Voice Mail System was submitted to a
Nationally Recognized Testing Laboratory (NRTL) for safety approvals. Before
installing the equipment, check local electrical codes that apply to the installation of
telephone and electronic equipment. The following safety guidelines are taken from
UL document 1459, Issue 2, which is product safety specification governing
telephone equipment.

General Safety Guidelines

When installing and using telephone equipment, the basic safety precautions
described below should always be followed to reduce the risk of fire and/or electrical
shock:
1-6
ICE Voice Mail Card Installation & Maintenance Manual
Read and understand all instructions.
Follow all warnings and instructions that are marked on the product.
Unplug the product from the wall outlet before cleaning. DO NOT apply any
liquid or aerosol cleaners directly to the unit.
Do not use this product near any sources of water or in a wet environment.
Do not place this product on an unstable shelf or table. The product may fall,
causing serious damage to the product. This damage may compromise the safety
features of the equipment. It is recommended to install the Emerald ICE Flash
Voice Mail System card by mounting it on a flat, dry wall surface.
Air ventilation openings are provided in the equipment for ventilation to protect
it from overheating. These openings must not be blocked or covered, especially
the wiring opening on the bottom of the unit. The Emerald ICE Flash Voice Mail
System card should never be placed near or over any type of heating radiator or
heat register. In addition, Emerald ICE Flash Voice Mail System card should not
be installed in an enclosed cabinet unless proper ventilation is provided.