Table Of Contents; Parts Required; Tools/Hardware Required; Staining Wood Panel Fronts - Monogram Fresh Food Custom ZIFI240 Installation Instructions Manual

CONTENTS
Important Information .................................................2
Parts Required ..............................................................4
Tools/Hardware Required ............................................4
Staining Wood Panel Fronts ........................................4
Caring for Your Stainless Steel .....................................4
Product Location ...........................................................4
Install Water Line .........................................................5
Design Guide (ZIFI240, ZIFS240, ZIBI240, ZIBS240)
The Installation Space ...................................................6
Side-by-Side Installations .............................................7
For Stainless Steel Models ZIFS240, ZIBS240 ............8
Flush and Standard Installation .....................................8
Product Clearances .......................................................8
For Custom Models ZIFI240, ZIBI240 ...........................9
Standard Installation ......................................................9
Product Clearances .......................................................9
Installation Instructions
Step 1, Remove Packaging and Installation Parts ......10
Step 2, Reversing the Door .........................................10
Step 3, Install Custom 3/4" Door Panel and Handle .....13
Step 4, Level ...............................................................14
Step 5, Connect Water Supply ...................................14
Step 6, Connect Power ...............................................15
Step 7, Slide Product into Cutout ................................15
Step 8, Set Temperature Controls ..............................15
ZIFI240 AND ZIBI240 MODELS ONLY

PARTS REQUIRED

• Custom handle
• Assembled overlay panel
• Screws

TOOLS/HARDWARE REQUIRED

• Adjustable wrench
• Carpenter's glue (ZIFI240 and ZIBI240 models only)
• Screwdriver (ZIFI240 and ZIBI240 models only)
4
Installation Instructions
PARTS SUPPLIED
• Handle side trim
• Optional black or
stainless steel toekick
WARNING
CUT HAZARD
Cabinet edges along stamp/cut-out areas may be sharp.
Avoid placing hands, fingers, or other appendages near
these areas. Failure to do so can result in cuts.
AVERTISSEMENT
Les bords de la caisse et les zones comportant un code
d'identication ou des découpes peuvent être tranchants.
Garder les mains, les doigts ou autres appendices éloignés
de ces zones. Le non-respect de cette instruction peut causer
des coupures.

STAINING WOOD PANEL FRONTS

The drawer fronts are unfinished cherry wood. During
use, oil from hands may accumulate and stain the wood.
• The drawer fronts may be stained and sealed to
match adjacent cabinetry.
• Apply the stain and sealer according to the
manufacturer's instructions. To avoid unpleasant odor,
keep the door open to ventilate and allow the stain/
sealer to dry completely before using the product.
CARING FOR YOUR STAINLESS
STEEL
• Before installation or first use, we strongly advise that
you polish the stainless steel exterior and handle with
a commercially available stainless steel cleaner such
as Stainless Steel Magic.™ To preserve and protect
the fine finish, we also strongly advise that you apply
stainless steel cleaner monthly.
REFRIGERATOR LOCATION
Do not install the refrigeratoe/freezer where the
temperature will go below 55°F (13°C). It will not run
often enough to maintain proper temperatures.
Do not install the refrigeratoe/freezer where
temperatures will go above 100°F (37°C). It will not
perform properly.
Do not install the refrigeratoe/freezer in a location
exposed to water (rain, etc.) or direct sunlight.
Install it on a floor strong enough to support it fully
loaded.
Risque de coupure
31-1000642