Weighing/Counting With Tolerance Range; Parameter Selection (See Also Chapter 14.2) - KERN CWS Operating Instruction

13 Weighing/counting with tolerance range

This function enables weighing of a certain weight or piece number within fixed toler-
ances, e. g. for control weighings. The achievement of tolerance limits is indicated by
an optical/acoustic signal.
+
TOL
-

13.1 Parameter selection (see also chapter 14.2)

1. Switch off the balance
2. Keep pressing the
key. The first function F-00 will be
shown and flashing. Then let go of both
keys.
3. Call up the "fill to target function" by press-
ing 5 on the numeric keypad.
4. Press the key for the current setting to
appear
5. Enter the desired mode (see chpt. 14.2)
using the numeric keypad.
6. Use the -key to store. The next menu
item "F-05-02" used to select data to be
compared appears.
0 = Count data
1 = Weight data
CWS-BA-e-0610
Overlay
Piece number / weight above upper tolerance limit
Piece number / weight within tolerance range
Piece number / weight below lower tolerance limit
key and press the
indicates:
F-00
F-05
F-05-01
F-05-01
F-05-02
0
1
1
31