Reference Piece Number 5, 25, 50 Or 100 - KERN CWS Operating Instruction

9.2.2 Reference piece number 5, 25, 50 or 100

1. Turn on balance by pressing the ON/OFF
key. The three LEDs on the keys "piece
weight by" are flashing. If this is this not
the case, press the
place the tare container on the balance
2. Press button
A tare container will automatically be
tared.
3. To select the reference piece number
press the key repeatedly until the de-
sired reference piece number appears.
10 → 5 →25 →50 →100 →10.
The larger the reference quantity, the
higher the counting exactness.
4. Place the selected piece number to act as
reference weight on the balance. The
weight of the pieces will be displayed.
The key is flashing.
5. Press button The display shows
"------" for a moment, while the reference
weight is being calculated. Dead stop
control is carried out and the calculated
reference weight appears on the display.
Note:
If "Add ##" appears on the display, you can
use this option to carry out reference optimi-
sation as the size of the sample was insuffi-
cient for an accurate count. Place the re-
quired pieces on the balance for reference
optimisation.
Now you can place the parts to be counted onto the weighing plate.
All piece number parameters of your load are displayed.
20
- key. If desired,
0.000
a
If required, tare by using TARE
0.000
a
0.280
a
0.280
a
Weight of pieces
CWS-BA-e-0610
10
ADD
Kg g
50
ADD
Kg g
50
ADD
Kg g
50
5.61200
Kg g
Calculated reference weight