Menu Overview - KERN CWS Operating Instruction

14.2 Menu overview

F- 01-X operation
Function Parameter
selection
key
Operating mode
0*
F-01-01
1
"Add##" additional piece number requirement (see notes "chpt. 9.2.1")
The additional piece number demand ensures during piece counting that no insufficient
reference weight is used as this could result in inaccurate results. It is possible to en-
able or disable this function.
0
F-01-02
1*
2
F-01-03 0
Display of last reference weight used
Each time the balance is turned on the last used reference weight will be displayed. It
is possible to enable or disable this function.
F-01-04
0*
1
Content ID memory
00
Tare value
F-01-05
00
Tolerance
limit
CWS-BA-e-0610
Standard Operation. All functions and keys are available
Simplified operating mode Reference weight can be determined by
weighing. All other keys are disabled (chpt.. 7.11)
"Add" function disabled. Light reference weight is accepted without
"Add" demand.
It is possible to enter the reference weight without the required addi-
tional "Add" pieces (via ENTER key).
It is not possible to enter the reference weight without the required
additional "Add" pieces (via ENTER key).
Always use this setting
Last used reference weight will be deleted
Last used reference weight will be displayed automatically
The ID memory merely contains the reference weight
You may select which other data should be stored in addition to the ref-
erence weight by entering 0 (no) or 1(yes) for the data (tare value or
tolerance limit).
Example: 10 = ID memory contains reference weight and tolerance limits
Description of function
35