Optional Reference Piece Number - KERN CWS Operating Instruction

9.2.3 Optional reference piece number

1. Turn on balance by pressing the
ON/OFF key. The three LEDs on the
keys "piece weight by" are flashing. If
this is this not the case, press the
key. If desired, place the tare container
on the balance
2. Press button
A tare container will automatically be
tared.
3. Enter the reference piece number via
the numeric keypad.
(Incorrect inputs can be deleted by
pressing the C key
4. Place the entered piece number to act
as reference weight on the balance.
The weight of the pieces will be dis-
played.
The key is flashing.
5. Press button The display shows "-----
-" for a moment, while the reference weight
is being calculated. Dead stop control is
carried out and the calculated reference
weight appears on the display.
Note:
If "Add ##" appears on the display, you can
use this option to carry out reference opti-
misation as the size of the sample was in-
sufficient for an accurate count. Place the
requested piece number to act as refer-
ence optimisation on the balance.(see note
chpt.. 9.2.1).
Now you can place the parts to be counted onto the weighing plate.
All piece number parameters of your load are displayed.
CWS-BA-e-0610
).
-
0.000
a
If required, tare by using TARE
0.000
a
0.112
a
0.112
a
Weight of pieces
10
ADD
Kg g
20
ADD
Kg g
20
ADD
Kg g
20
5.61200
Kg g
Calculated reference weight
21