Awa Function (Audible Weighing Assist = Acoustic Fill-To-Target); Enabling/Disabling The Awa Function - KERN CWS Operating Instruction

15.2 AWA function (audible weighing assist = acoustic fill-to-target)

This function is used to support the approximation to a target piece number (e.g.20
items) by a gradually intensifying acoustic signal.
There are three operating modes. These are selected with the help of the TARGET
key.
Mode off:
Target mode:
Interval mode (int):
• A signal is given starting from "piece number -9". Whilst you are adding pieces
and approach the target piece number the acoustic signal will change the inter-
vals of beeps. These become shorter and will stop as soon as the piece number
has been reached.
• The acoustic signal bleeps again for "target piece number +1, 2, 3 or 4" items.
• The minimum piece number is set to 10.
• If the piece number is set to less than 50 in the interval mode, the acoustic signal
will start sounding at "target piece number -5".
• It is not possible to set a minus target and an interval count at the same time.
However, the AWA function also works for negative piece counts.
• The AWA function must be disabled if the acoustic signal is used for toler-
ance control.

15.2.1 Enabling/disabling the AWA function

To disable the AWA function:
1. Press the key, the current mode
appears.*
2. Press the key repeatedly until "off"
appears.
3. Confirm by pressing the
the balance will return to count mode.
* Information: To return to weighing mode without having to change the setting, press
the CE key.
44
AWA function disabled
Setting a target piece number
When in interval mode, a target piece number (e.g. 20
items) for repeat counts may be selected several times
(e.g. 20, 40, 60, 80 items).
key and
OFF
0.000
Kg
CWS-BA-e-0610