Determination Of The Reference Weight By Weighing; Reference Piece Number 10 - KERN CWS Operating Instruction

9.2 Determination of the reference weight by weighing

9.2.1 Reference piece number 10

1. Turn on balance by pressing the ON/OFF
key. The three LEDs on the keys "piece
weight by" are flashing. If this is this not the
case, press the
the tare container on the balance
2. Press button
A tare container will automatically be tared.
3. Place10 single pieces to act as reference
weights on the balance. The weight of all 10
pieces will be shown
4. Press button The display shows "------"
for a moment, while the reference weight is
being calculated. Dead stop control is carried
out and the calculated reference weight ap-
pears on the display.
Note:
If "Add ##" appears on the display, you can
use this option to carry out reference optimi-
sation as the size of the sample was insuffi-
cient for an accurate count.
Either add the required piece number or ig-
nore the message "Add ##" and continue the
counting process by pressing the ENTER
key. (This, however, will not give accurate
results). See also function "F-01-02", chpt..
14.2
5. Now you can place the parts to be counted
onto the weighing plate. All piece number pa-
rameters of your load are displayed.
For further information about reference opti-
misation see chpt. 15.1).
CWS-BA-e-0610
- key. If desired, place
0.000
a
If required, tare by using TARE
0.056
a
0.056
a
Weight of pieces
0.004
a
10
ADD
Kg g
10
ADD
Kg g
10
5.61200
Kg g
Calculated reference
weight
10
ADD 15
Kg
19