Automatic Adding-Up; Displaying A Sum Total; Deleting All Stored Weighing Data; M- Function - KERN CWS Operating Instruction

12.2 Automatic adding-up

When the automatic summation function F-03-01 is enabled (for setting "1", see chpt.
14.2.), the individual weighing values will be automatically added to the summation
memory without having to press the M+ after a rest position control was carried out.
An acoustic signal indicates when all the weighing values have been added to the
summation memory.
• Same procedure as for manual adding-up, see chpt. 12.1 but without pressing
the M+ key.
• Please note that the balance must be unloaded between the individual weigh-
ing procedures (display < +5d).
• If function F-03-02 is set to "1" it is only possible to add positive counts (see
chpt. 14.2.)

12.3 Displaying a sum total

1. Press the key and the total piece
number as well as the number of weigh-
ings will appear.
Indicated by the [
"TOTAL" and "N"
2. Press the key again.
The balance returns automatically into
weighing mode.

12.4 Deleting all stored weighing data

1. Keep pressing the
2. This deletes the M+ memory.
The [ ] display next to "M+" and „TOTAL" disappears.
Notes:
Pressing the
mation memory.
Data remains stored even after the balance was disconnected from the mains.

12.5 M- function

• The balance can subtract summation data from the M+ memory by
pressing the
• For this purpose enable function F-09-01 in the menu (for setting "1",
see chpt. 14.2).
• This function is not used to delete the last M+ addition but to subtract
the summation data instead of adding. The sum total of the number of
weighings will be increased.
• There is no automatic function M-.
30
] display next to
key, press the
key will delete merely the display but not the data in the sum-
key
Total number of pieces
1234
0.000
Kg
a
Number weighing processes
key, then let go of both.
CWS-BA-e-0610
7