Optional Reference Piece Number Without Using The - Key - KERN CWS Operating Instruction

9.2.4 Optional reference piece number without using the
1. Turn on balance by pressing the
ON/OFF key. The three LEDs on the
keys "piece weight by" are flashing. If
this is this not the case, press the
key. If desired, place the tare container
on the balance and tare by pressing the
TARE key.
2. Place the piece number to act as refer-
ence weight on the balance. The weight
of the pieces will be displayed.
3. Enter the piece number via the numeric
keypad.
(Incorrect inputs can be deleted by
pressing the C key
The key is flashing.
4. Press button The display shows
"------" for a moment, while the refer-
ence weight is being calculated. Dead
stop control is carried out and the calcu-
lated reference weight appears on the
display.
Note:
If "Add ##" appears on the display, you can
use this option to carry out reference opti-
misation as the size of the sample was in-
sufficient for an accurate count. Place the
requested piece number to act as refer-
ence optimisation on the balance.(see note
chpt.. 9.2.1).
Now you can place the parts to be counted onto the weighing plate.
All piece number parameters of your load are displayed.
22
).
-
0.000
a
0.112
a
0.112
a
0.112
a
Weight of pieces
- key
0
0.00000
Kg g
0
0.00000
Kg g
20
ADD
Kg g
20
5.61200
Kg g
Calculated reference weight
CWS-BA-e-0610