Display Of Set Tolerance Limits; Key Instead Of Setting In Menu - KERN CWS Operating Instruction

13.2 Display of set tolerance limits

Condition: F-09-01 = „0", see chpt. 14.2
1. Switch on balance
2. Press the key and the set upper
tolerance limit will be shown and flash-
ing.
3. Press the key again and the set
lower tolerance limit will be shown and
flashing.
4. Press the
ance will return to counting mode
13.3 Changing set tolerance limits by using the
menu
1. Press the key and the set upper
tolerance limit will be shown and flash-
ing. To change the upper tolerance limit,
enter the desired value via the numeric
keypad.
2. Press the key, the new upper limit
will be stored and the lower limit dis-
played.
3. To change the lower tolerance limit, en-
ter the desired value via the numeric
keypad
4. Press the key and the new lower
limit will be stored and the balance will
return to counting mode.
5. If you do not wish to store the new limit,
press the key. The balance returns
to weighing mode
Stored tolerance limits will be retained even after the balance was turned off.
CWS-BA-e-0610
key again and the bal-
0.000
Kg
a
0.000
Kg
a
key instead of setting in
0.000
Kg
a
0.000
Kg
a
102
Hi
98
Lo
102
Hi
98
Lo
33