Retrieving A Stored Reference Weight Via Id No - KERN CWS Operating Instruction

9.4 Retrieving a stored reference weight via ID no.

For storing a reference weight via an ID no. see chpt. 11.1
1. Turn on balance by pressing the
ON/OFF key. The three LEDs on the
keys "piece weight by" are flashing. If
this is this not the case, press the
key.
2. Press key,
"id-00" appears with flashing „00".
3. Enter ID no. via numeric keyboard (In-
correct inputs can be deleted by press-
ing the C key
).
The ENTER key is flashing.
4. Confirm by pressing the
stored reference weight appears.
Note:
If no reference weight exists for the en-
tered ID no. this will be indicated by an
acoustic signal and the message "no
id". The process will be reset to step 3.
Now you can place the parts to be counted onto the weighing plate.
All piece number parameters of your load are displayed.
Notes:
• "id 00" is a special memory area. It always contains the most recently entered
reference weight.
• A reference weight is stored automatically under "id 00" where it remains until a
new reference weight is stored.
• If a reference weight is deleted by pressing the
via "id 00".
24
a
a
key, the
a
Id 00
0.000
Kg
Id 12
0.000
Kg
12.0000
0.000
Kg
key it can still be invoked
CWS-BA-e-0610
0
g