Porsche 911 Carrera Technical Manual page 87

Final drive -Differential, differential lock
911 Carrera 4 (996)
3. Grease bushing with approx. 3 g of Olista
Longtime 3EP.
240_98
A -Bellows
B -Cardan shaft
C -Central shaft groove
Tightening torques:
Cardan shaft on transmission
flange (MID) = 45 Nm (33 ftlb.)
A -Bushing
Transmission support;
transmission carrier
on transmission
mount (M 10) =
238_98
4. Grease splines of the cardan shaft with Olista
Longtime 3 EP. Slide shaft into the central
shaft splines and fit on the transmission side.
65 Nm (48 ftlb
Transmission support
on body (MID) =
5. Push bellows forward until it engages in the
groove of the central shaft. Check whether the
bellows is seated properly by pulling on it.
65 Nm (48 ftlb.)
8
Removing and installing cardan shaft
Printed in Gennany -14, 1998
39 02 19
C4539105
39 -108