Porsche 911 Carrera Technical Manual page 143

Manual transmission -Actuation, ass. housing
911 Carrera (996)
Note:
No.
Designation Qty.
Removal
Installation
1
Screw plug (with sealing
ring)
1
Clean, tighten to 30 Nm
(22 ftlb.), Replace the
sealing ring
Tighten to 10 Nm
(7.5 ftJb.)
2
Oval-head screw 2
3 Guide tube
1
4 Shaft seal 1
Install only after fitting the
gear set (also see Servo
No. 35 50 19)
5
Closure cap
1
6
Bushing
1
Drive out from the inside
with special tool 9515
7 Shaft seal
1
8 Ball sleeve 4
Do not grease, oil or
clean with solvent (e.g.
solvent naphtha). Drive in
up to the stop with
special tool 9515
Drive in with special tool
9252 as far as the
mounting face. Fill the
space between the dust
and sealing lips with
grease (e.g. Liqui Moly)
Drive in with special
tool 9648 (installation
depth 0.6 mm)
Remove with special
tools VW 771,
VW 771/15 and suitable
internal puller (e.g.
Messrs. Schrem 14-20)
Drive out with aluminium or
copper mandrel, changing
sides
9
Bearing outer race
1
Drive in as far as the
stop with special tools
3062 and VW 295
10 1
Drive out from the inside
with special tool VW 513
Drive in with special tool
9247/4 and mandrel of
special tool P 254
Bearing outer race
Disassembling and assembling transmission housing -GT3
GT334231 Printed in Germany -29, 1999
34 -234
34 37 37