Note
It is essential to fix the drive pinion with special
tool 9562 during the measurement.
390_99
9. Repeat the measuring procedure another
three times after continuing to turn the crown
wheel through 900 in each case. The
measured values must not differ by more than
0.03 mm.
Note
The backlash to be set is inscribed on the edge
of the crown wheel. The permissible deviation is
:t 0.04 mm.
10. The spacer rings (Sl + S2) must be changed
again if the prescribed backlash is not
attained. The total shim thickness (S tot.)
must not change, however.
39 08 15
Adjusting drive set -GT3
Printed in Germany -29.
1999
39 -230
GT339227