Porsche 911 Carrera Technical Manual page 82

911 Carrera 4 (996)
Final drive -Differential, differential lock
7. Undo fastening nuts for front transmission
support and unscrew the studs.
Installation
Install in reverse order, observing the following
points:
1. Carefully lift in the transmission with a
universal transmission jack. When doing
so, do not damage the coolant pipes.
j;~
::::::=
~I
~,
~.::'
A
.If
CD
~-l';:;;:~~
A -Transmission support
B -Hexagon nut
C -Stud
245_98
8. Carefully lower the transmission out.
When doing so, avoid damaging
the coolant pipes.
250_98
2. Push studs through the front transmission
mounts and screw into the front-axle cross
member.
3. Fasten transmission mounts on the front-axle
cross member and on the body.
Note
If the hexagon-head bolt (M lax gO) was
undone on the rear transmission support,!
transmission mount, it is important to tighten
the front transmission support first, then the
rear transmission support and the MIa x gO
screw on the rear transmission mount last.
39 88 19 Removing and installing front final drive
Printed in Germany -14, 1998 C4539101
39 -103