Removing and installing support for final drive
Removal
1. Remove final drive
(refer to Servo No. 39 88 19).
2. Unscrew fastening screws and remove
support.
Installation
1. Fit support in the correct position
(angled side facing upwards).
A -Tabs
48O_98
2. Tighten fastening screws in two stages.
1st stage:
Screw both screws to 5 Nm (3.7 ftlb.).
2nd stage:
Tighten both screws to 65 Nm (48 ftlb.).
3. Install final drive.
481_98
Note
At the beginning of the series, supports with
tabs were installed. These supports must be
fitted with the tabs facing downwards.
39 62 19
Removing and installing support for final drive
C4s39127
Printed in Germany
-18,
1998
39 -128