Porsche 911 Carrera Technical Manual page 131

Note:
No.
Designation
Qty.
Removal
Installation
43
Oval-head screw
2
Tighten to 10 Nm
(7.5 ftlb.)
44 Guide tube
45
Shaft seal
1
See Servo No. 35 50 19
Install only after fitting the
gear set
46
Transmission housing
1
* If the differential is still installed, the locking pieces (Nos. 40, 41, 42) must be taken out before the shift
rods (Nos. 4, 6, 20) and tensioning plate (No. 38) can be removed.
Note
As the bearing inner races (Nos. 10, 19 and 32) are subject to tolerances (transition fit), they could have
a loose or tight fit on the shaft.
34 35 37 Disassembling and assembling transmission
Printed in Germany -29, 1999 GT334217
34 -221