Porsche 911 Carrera Technical Manual page 46

Removing and installing transmission
Removal
1. Remove underbody panels (middle and rear).
7. Unscrew the clutch slave cylinder and hang up
at the side with the hose connected.
2. Remove the cross member which passes
under the transmission.
Note
The clutch pedal must not be pressed if the
slave cylinder has been removed.
Danger of injury from flying piston rod.
Affix a warning note in the vehicle!
3. Secure the engine in installation position with
special tool 9624/1. To do this, remove the
mounting for the stabilizer, swivel the
stabilizer forward and screw on special tool
9624/1 with four fastening screws.
Screw in the pressure screw until the
pressure disc has contact with the crankcase,
8. Disengage shift and selector cables on the
transmission:
(o/f
-
IJ'
"-'"
-;;/-:::; ~
..,,~
133-97
132-97
4. Remove drive shafts at the transmission and
protect the shafts against damage (use scrap
pieces of hose with a diameter of 30 mm).
Note
The shift and selector cables must not be
excessively bent or kinked.
Pull off shift and selector cables at the
transmission shift and selector levers.
5. Disconnect the plug connection for the
reversing light switch.
6. Unclip the hydraulic line for the clutch slave
cylinder at the side transmission case cover.
Removing and installing transmission G 96
Printed in Germany, 1997
34 -4
34 35 19
996341