Porsche 911 Carrera Technical Manual page 32

Clutch, actuation
911 Carrera (996)
3. Installation and adjustment specification for
boost spring bracket.
Install preassembled boost spring bracket
with clutch pedal lever.
~""~
To do this:
~
-~-;::?'
",
~
Step 1:
Tighten the three fastening nuts (arrows) only
slightly (the bracket must still be movable).
4.
1.+5.
JII
\I~
~
2.
Step 2:
Tighten the clutch master cylinder to 10 Nm
(7.5 ftlb.) (if the clutch master cylinder
was detached).
32_98
Step 3:
Press the clutch pedal against the direction of
travel until the pull stop in the clutch master
cylinder is reached.
Note
The push rod of the clutch save cylinder should
not be lubricated in general (for all versions).
4. Fit new retainer on the pedal bearing axle and
subsequently secure the retainer by wedging
it with a mandrel.
Step 4:
Remove cotter pin (retaining pin) on the spring
cup so that the clutch pedal is pressed against
the rubber stop in the boost spring bracket.
Step 5:
The bracket is screwed down with the clutch
pedal pressed back (to make full use of the
slots). Tighten hexagon nuts (arrows) in
the prescribed sequence.
Tightening torque: 7.5 Nm (5.5 ftlb.).
Sequence: 5a / 5b / 5c
5. Install clutch pedal switch.
First pull operating plunger out of the switch
as far as it will go.
By means of its self-adjustment function,
the switch then compensates for tolerances
in the pedals.
30 -15
30 05 19 Removing and installing the clutch pedal
Printed in Germany -18, 1998 996309