Table of Contents
Advertisement
Chapter 1 Introducing the Device
1.5.2 Activate WPS
Make sure the POWER LED is on (not blinking).
1
Press the WLAN/WPS button for more than eight seconds and release it. Press the WPS button on
2
another WPS -enabled device within range of the Device. The WLAN/WPS LED should flash while
the Device sets up a WPS connection with the wireless device.
Note: You must activate WPS in the Device and in another wireless device within two
minutes of each other. See
1.6 The RESET Button
If you forget your password or cannot access the web configurator, you will need to use the RESET
button at the back of the device to reload the factory-default configuration file. This means that you
will lose all configurations that you had previously and the password will be reset to the default.
1.6.1 Using the Reset Button
Make sure the POWER LED is on (not blinking).
1
To set the device back to the factory default settings, press the RESET button for ten seconds or
2
until the POWER LED begins to blink and then release it. When the POWER LED begins to blink,
the defaults have been restored and the device restarts.
22
Section 7.8.4 on page 144
for more information.
P-870HNU-51b User's Guide
Advertisement
Table of Contents
Troubleshooting
