The Queue Setup Screen - ZyXEL Communications P870HNU-51B User Manual

Chapter 15 Quality of Service (QoS)
The following table describes the labels in this screen.
Table 60 QoS General
LABEL
Enable QoS
WAN Managed
Upstream
Bandwidth
Apply
Cancel

15.4 The Queue Setup Screen

Click QoS > Queue Setup to open the screen as shown next.
Use this screen to configure QoS queue assignment.
Figure 99 QoS Queue Setup
194
DESCRIPTION
Select the check box to turn on QoS to improve your network performance.
Enter the amount of upstream bandwidth for the WAN interface that you want to
allocate using QoS.
The recommendation is to set this speed to match the interface's actual
transmission speed. For example, set the WAN interface speed to 100000 kbps if
your Internet connection has an upstream transmission speed of 100 Mbps.
You can set this number higher than the interface's actual transmission speed.
The Device uses up to 95% of the DSL port's actual upstream transmission speed
even if you set this number higher than the DSL port's actual transmission speed.
You can also set this number lower than the interface's actual transmission speed.
This will cause the Device to not use some of the interface's available bandwidth.
If you leave this field blank, the Device automatically sets this number to be 95%
of the DSL port's actual upstream transmission speed.
Click Apply to save your changes back to the Device.
Click Cancel to begin configuring this screen afresh.
P-870HNU-51b User's Guide