Static Route Edit - ZyXEL Communications P870HNU-51B User Manual

13.2.1 Static Route Edit

Click the Add button in the Static Route screen. Use this screen to configure the required
information for a static route.
Figure 95 Static Route: Add
Figure 96 Static Route: Add: IPv6
The following table describes the labels in these screens.
Table 58 Static Route: Add
LABEL
IP Version
Destination IP
Address
Destination IP
address/prefix
length
IP Subnet Mask
Use Interface
Use Gateway IP
Address
Back
Apply
Cancel
P-870HNU-51b User's Guide
DESCRIPTION
Select the IP version to use for this static route's traffic.
If IPv4 is selected as the IP version, this parameter specifies the IP network
address of the final destination. Routing is always based on network number. If
you need to specify a route to a single host, use a subnet mask of
255.255.255.255 in the subnet mask field to force the network number to be
identical to the host ID.
If IPv6 is selected as the IP version, this parameter specifies the IPv6 network
address and prefix length of the final destination. Routing is always based on
network number. If you need to specify a route to a single host, use the prefix
length of 128 to force the network number to be identical to the host ID.
Enter the IP subnet mask here.
Select a WAN or LAN interface through which the traffic is sent. You must have the
WAN interface(s) already configured in the WAN screens.
Select this option and enter the IP address of the next-hop gateway. The gateway
is a router or switch on the same segment as your Device's interface(s). The
gateway helps forward packets to their destinations.
Click Back to return to the previous screen without saving.
Click Apply to save your changes back to the Device.
Click Cancel to begin configuring this screen afresh.
Chapter 13 Static Route
187