Wps Button; Reset Button; Wall Mounting - ZyXEL Communications EX3510-B1 User Manual

1.5.3 WPS Button

You can use the WPS button to quickly set up a secure WiFi connection between the Zyxel Device and a
WPS-compatible client by adding one device at a time.
To activate WPS:
Make sure the POWER LED is on and not blinking.
1
Press the WPS button for one second and release it.
2
Press the WPS button on another WPS-enabled device within range of the Zyxel Device within 120
3
seconds. The WPS LED flashes green while the Zyxel Device sets up a WPS connection with the other WiFi
device.
Once the connection is successfully made, the WPS LED will turn off.
4

1.5.4 RESET Button

If you forget your password or cannot access the Web Configurator, you will need to use the RESET
button to reload the factory-default configuration file. This means that you will lose all configurations
that you had previously. The password will be reset to the factory default (see the device label), and the
LAN IP address will be "192.168.1.1".
Make sure the POWER LED is on (not blinking).
1
To set the device back to the factory default settings, press the RESET button for more than 5 seconds or
2
until the POWER LED begins to blink and then release it. When the POWER LED begins to blink, the defaults
have been restored and the device restarts.
Do NOT turn off the Zyxel Device while it is restarting. If you must turn off
the Zyxel Device, wait until it has fully restarted – the 2.4G and/or 5G
WiFi LEDs should be blinking.

1.5.5 Wall Mounting

You may need screw anchors if mounting on a concrete or brick wall.
Table 4 Wall Mounting Information
Distance between holes
Screws
Screw anchors (optional)
The following figure introduces the specifications of the screws and screws anchors for wall mounting.
Chapter 1 Introducing the Zyxel Device
88 mm
Two
Two
EX3510-B1 User's Guide
23