Chapter 1 Introducing the ZyXEL Device
1.6.1 Using the Reset Button
Make sure the POWER LED is on (not blinking).
1
To set the device back to the factory default settings, press the RESET button for
2
ten seconds or until the POWER LED begins to blink and then release it. When the
POWER LED begins to blink, the defaults have been restored and the device
restarts.
1.7 The WPS WLAN Button (P-870HW Series only)
You can use the WPS WLAN ON/OFF button (
turn the wireless LAN off or on. You can also use it to activate WPS in order to
quickly set up a wireless network with strong security.
1.7.1 Turn the Wireless LAN Off or On
Make sure the POWER LED is on (not blinking).
1
Press the WPS WLAN ON/OFF button for one second and release it. The WLAN/
2
WPS LED should change from on to off or vice versa.
1.7.2 Activate WPS
Make sure the POWER LED is on (not blinking).
1
Press the WPS WLAN ON/OFF button for more than five seconds and release it.
2
Press the WPS button on another WPS -enabled device within range of the ZyXEL
Device. The WLAN/WPS LED should flash while the ZyXEL Device sets up a WPS
connection with the wireless device.
Note: You must activate WPS in the ZyXEL Device and in another wireless device
within two minutes of each other. See
information.
26
) on the top of the device to
Section 7.10.4 on page 109
P-870H/HW Series User's Guide
for more