Using Wps - ZyXEL Communications P870HNU-51B User Manual

Click the WLAN Station List hyperlink in the Status screen. You can see if any wireless client has
9
connected to the Device.

2.3.2 Using WPS

This section shows you how to set up a wireless network using WPS. It uses the Device as the AP
and ZyXEL NWD210N as the wireless client which connects to the notebook.
Note: The wireless client must be a WPS-aware device (for example, a WPS USB adapter
or PCMCIA card).
There are two WPS methods to set up the wireless client settings:
• Push Button Configuration (PBC) - simply press a button. This is the easier of the two
methods.
• PIN Configuration - configure a Personal Identification Number (PIN) on the Device. A wireless
client must also use the same PIN in order to download the wireless network settings from the
Device.
Push Button Configuration (PBC)
Make sure that your Device is turned on and your notebook is within the cover range of the wireless
1
signal.
Make sure that you have installed the wireless client driver and utility in your notebook.
2
Press the WPS button on your notebook within range of the Device.
3
The wireless LAN of the Device is disabled by default. Press the WLAN/WPS button for three
4
seconds and release it when the LED turns green. The wireless LAN is on. Then press the WLAN/
WPS button for more than eight seconds and release it when the WLAN/WPS LED is blinking
orange.
P-870HNU-51b User's Guide
Chapter 2 Tutorials
33