The 3G Backup Screen - ZyXEL Communications P870HNU-51B User Manual

The following table describes the labels in this screen.
Table 26 WAN Configuration: Configuration Summary
LABEL
Connection Type
Service Name
Service Category
IP Address
Service State
NAT
Full Cone NAT
Quality Of Service
IGMP Multicast
MLD Multicast
IPv6
Back
Apply/Save

5.6 The 3G Backup Screen

Use this screen to configure your 3G settings. Click Network > WAN > 3G Backup.
At the time of writing, the 3G cards you can use in the Device are Huawei E220, Huawei E169u,
Huawei E161, Qisda H21, ZTE MF100, ZTE MF110 and Huawei E1752.
Note: The actual data rate you obtain varies depending the 3G card you use, the signal
strength to the service provider's base station, and so on.
P-870HNU-51b User's Guide
DESCRIPTION
This is the encapsulation method used by this connection.
This is the name of the service.
This is the ATM traffic class.
This field is blank for a PTM connection.
This shows whether the WAN IP address is assigned by the ISP, manually
configured or not configurable.
This shows whether this service is active or not.
This shows whether NAT is active or not for this connection.
This shows whether full cone NAT is active or not for this connection.
This shows whether QoS is active or not for this connection.
This shows whether IGMP multicasting is active or not for this connection.
This shows whether MLD multicasting is active or not for this connection.
This shows whether IPv6 is active or not for this connection.
Click this button to return to the previous screen.
Click this button to save your changes.
Chapter 5 WAN Setup
10
5