Honeywell UDC3500 Product Manual page 89

Function Prompt
Lower Display
MATH K
CALC HI
CALC LO
ALG1 INA
ALG1 INB
10/05
Selections or
Range of Setting
Upper Display
0.001 to 1000 floating
–999. To 9999. Floating
(in engineering units)
–999. To 9999. Floating
(in engineering units)
INPUT 1
INPUT 2
INPUT 3
INPUT 4
INPUT 5
LP1OUT
LP2OUT
IN AL1
IN AL2
INPUT 1
INPUT 2
INPUT 3
INPUT 4
INPUT 5
LP1OUT
LP2OUT
IN AL1
IN AL2
UDC3500 Universal Digital Controller Product Manual
Parameter
Definition
WEIGHTED AVERAGE RATIO OR MASS FLOW
ORIFICE CONSTANT (K) FOR MATH
SELECTIONS—Only applicable for algorithms
W AVG or General Math selections √MuDIV,
√MULT, MuDIV, or MULT.
CALCULATED VARIABLE HIGH SCALING
FACTOR FOR INPUT ALGORITHM 1—Used only
when Summer, Input Hi/Lo, or one of the General
Math functions was selected as the Input Algorithm.
See Note 2.
CALCULATED VARIABLE LOW SCALING
FACTOR FOR INPUT ALGORITHM 1—Used only
when Summer, Input Hi/Lo, or one of the General
Math functions was selected as the Input Algorithm.
See Note 2.
ALGORITHM 1, INPUT A SELECTION—
Represents one of the following selections:
INPUT 1
INPUT 2
INPUT 3
INPUT 4
INPUT 5
LOOP 1 OUTPUT—Should not be used for Three
Position Step Control applications
LOOP 2 OUTPUT—Should not be used for Three
Position Step Control applications
INPUT ALGORITHM 1
INPUT ALGORITHM 2
ALGORITHM 1, INPUT B SELECTION—
Represents one of the following selections:
INPUT 1
INPUT 2
INPUT 3
INPUT 4
INPUT 5
LOOP 1 OUTPUT—Should not be used for Three
Position Step Control applications
LOOP 2 OUTPUT—Should not be used for Three
Position Step Control applications
INPUT ALGORITHM 1
INPUT ALGORITHM 2
Configuration
75