Table of Contents
Advertisement
Rev 2.1
Push the latch
release
The board is short, therefore do not let go of it while sliding it out.
1.9
Inserting a Spine Board
1.
Start with the latches fully open, that is perpendicular to the front panel of the leaf.
2.
Hold the spine board by the sides with both latches fully open.
3.
Insert the board into its rail. The board should slide in without resistance.
4.
Push the board in until the hooks on the latches are touching the vertical bar.
5.
Now press both latches inward simultaneously. You should feel the latches are hooked into
the front panel.
6.
Press both latches applying some force to close them completely. The locking latch will
engage.
34
Figure 25: Ejector Latch
Management Module /Spine
Management Module /Spine
Figure 26: Management Module
RST
PSU
S.FANS
I2C
CONSOLE
MGT
Ejectors
Pull the module out of the
chassis
L.FANS
MASTER
MGT MAC:
00:02:C9:11:34:8A
Chassis Installation
Mellanox Technologies
Advertisement
Table of Contents
