Table of Contents
Advertisement
Rev 2.1
No remote IP connection is available at this stage.
2.
Configure a serial terminal program (for example, HyperTerminal, Minicom, or Tera Term)
on your host PC with the settings described in Table 3.
Table 3 - Serial Terminal Program Configuration
Parameter
Baud Rate
Data bits
Stop bits
Parity
Flow Control
3.
Login (from serial terminal program) as admin and use admin as password. This starts the
Mellanox configuration wizard.
4.
Go through the Mellanox configuration wizard. Table 4 shows an example of a wizard ses-
sion.
Table 4 - Configuration Wizard Session - IP Configuration by DHCP (Sheet 1 of 2)
Wizard Session Display (Example)
Mellanox configuration wizard
Do you want to use the wizard for initial configura-
tion? yes
Step1: Hostname? [switch-1]
Step 2: Use DHCP on eth0 interface? [yes]
46
Setting
9600
8
1
None
None
You must perform this configuration the first time you
operate the switch or after resetting the switch. Type
'y' and then press <Enter>.
If you wish to accept the default hostname, then press
<Enter>. Otherwise, type a different hostname and
press <Enter>.
Perform this step to obtain an IP address for the switch.
(eth0 is the management port of the switch.)
If you wish the DHCP server to assign the IP address,
type 'yes' and press <Enter>.
If you type 'no' (no DHCP), then you will be asked
whether you wish to use the 'zeroconf' configuration
or not. If you enter 'yes' (yes Zeroconf), the session
will continue as shown in Table 5.
If you enter 'no' (no Zeroconf), then you need to enter
a static IP, and the session will continue as shown in
Table 6.
InfiniBand Fabric Initialization and Management
Comments
Mellanox Technologies
Advertisement
Table of Contents
