Table of Contents
Advertisement
Rev 1.1
Leaf board screw
locations
6. After the cover is removed unscrew the 5 Philips screws and remove the board from the
casing.
7. Turn the board over and remove the heat sink from the board by unscrewing the 4 slotted
screws and remove the heat sink from the board.
2.4
Extracting a Spine Board
The Spine modules are located on the rear side of the product.
The Spine module is removed using snap handles.
1. Push outward on the latches to unlock the ejectors from the chassis.
2. Open the ejectors until they are 45 degrees from the module.
3. Pull out on the module using both ejectors.
10
Figure 7: Chassis Leaf
Extraction of the Modules
Heat sink screws
Advertisement
Table of Contents
