Table of Contents
Advertisement
Rev 2.1
The vertical supports may have to be moved so that the vertical support closest to the door is 6 cm
from the inside of the door. This may be required so that the shelf does not protrude from the rack.
1.6.2 ESD Connection
Before starting any procedure on the 5600 series switch system:
1.
Put an ESD prevention wrist strap on your wrist, and make sure there is good contact
between your body and the strap.
2.
Plug the other end of the wrist strap to a valid ground. Make sure that this is a tight fit.
1.6.3 Installation Procedure
Installing the chassis will be a lot easier if you can remove the sides of the rack.
You will need a fork lift, to move and insert the chassis into the rack.
1.6.3.1
Requirements
You will need:
• #2 phillips screwdriver
• a fork lift
• measuring tape
• One 9/16 box wrench
The installation will be much easier with a power screwdriver.
It is recommended to use AWG6 or 4mm diameter wire for grounding purposes.
14
If you move the vertical supports make sure that you reinstall them vertically
plumb.
• #3 phillips screwdriver
• a grounding lug
• ground wire of sufficient length and gauge to properly ground the
chassis
Chassis Installation
Mellanox Technologies
Advertisement
Table of Contents
