Registering Handsets With The Base; Using The Handset Charger - Talkswitch TS-860i User Manual

Registering handsets with the base

You must register the handsets with the base. You can use the handset charger, or
you can use the handset itself.
A base can support up to three handsets with three concurrent calls. It can
support up to eight handsets if they aren't all used at once. If you have more
than three handsets and are getting busy signals, add more bases to your
installation in order to handle more calls.
NOTE: If the handset you want to register is already registered with another base,
you need to deregister the handset from that base before you can register it with
a new base. See Deregistering a handset from a base on page 11.

Using the handset charger

1. Press the Reset button on the back of the base. A five-minute registration
period starts, which allows handsets to register with the base.
NOTE: If you have multiple bases, only reset one base at a time, and wait five
minutes before resetting the next base.
2. If the handset is turned off, press the Red Phone key to turn it on.
3. Place the handset in the handset charger. The handset automatically registers
with the base, and the Configure SIP Domain message appears on the
display. This message indicates that you must configure the TS-850i/TS-860i
as an IP extension, as described later. Once the handset is registered, the left
connection status indicator in the display will turn yellow. See Handset screen
— idle mode on page 6.
4. Once the handset is registered, you can place additional handsets in the
handset charger for registration. If the five-minute registration period has
expired, but the handsets aren't all registered, press the Reset button on the
back of the base to start a new registration period.
1 0 T S - 8 5 0 i A N D T S - 8 6 0 i U S E R G U I D E