Configuring The Outside Line Access Code; Extensions With Direct Line Access; Selecting Ring Tone; Adjusting The Display Angle - Talkswitch TS-600 User Manual

T S - 6 0 0 U S E R G U I D E
CONFIGURE THE OUTSIDE LINE ACCESS CODE
The outside line access code is dialed prior to any
number over 6 digits stored in the directory, speed
dial buttons, or the call log. A stored number with
6 or fewer digits is considered an internal number.
The outside line access code is not dialed for an internal
call. A 3 second pause is inserted automatically between
the outside line access code and the phone number.

Extensions with Direct Line Access

Direct Line Access allows you to access the outside phone lines directly, without
having to enter a line access code. If your TalkSwitch extension is programmed
for Direct Line Access, enter
features and dialing operate properly for your extension. Refer to your TalkSwitch
programming guide for more information.
To enter outside line access code:
MENU
1. Press the
2. Enter your outside line access code or
Direct Line Access.
SAVE
3. Press the

Selecting ring tone

You can select one of four ring tones for
this telephone:
MENU
1. Press the
2. The phone rings with Ring Tone 1 for about
2 seconds.
SAVE
3. Press the
4. Press the button or the
5. After the end of the desired ring tone, press the

Adjusting the display angle

You can optimize the LCD display by adjusting the viewing angle. To adjust the
LCD viewing angle, move the rear edge of the LCD module up or down.
6
#
as your line access code. This will ensure that
button followed by
button to store the access code.
button followed by
button to select Ring Tone 1; or
button to select another ring tone.
2
.
#
if your extension is configured for
3
.
SAVE
W W W.T A L K S W I T C H . CO M
Use Save to End
9
# = DLA Mode Enable
Enter Access Code
Use Save to End
Use / Enter to Select
1 = Ring tone 1
2 = Ring tone 2
3 = Ring tone 3
4 = Ring tone 4
button to select it.