Choosing To Waypoint; Choosing Final Waypoint; Confirming Checked Conditions Of The Route Plan - Furuno FEA-2107 Operator's Manual

6.7.1

Choosing TO waypoint

The system chooses a TO waypoint automatically. Check that it is the correct one. Note that waypoint number 1 is
not accepted. Use the Monitor Route dialog box to choose a waypoint.
6.7.2

Choosing final waypoint

This selection is used ONLY when the last waypoint should be different than the one defined last in your route. If
needed use the Monitor Route dialog box to choose it.
6.7.3

Confirming checked conditions of the route plan

You can check on the
Alarms page if
checked conditions
in the Alarms page
are used with the
route in route
monitoring.
If the text "Current
selection is different"
is displayed, use
Initial Settings>Chart
Alarm parameters to
make "Chart alarms"
selections. Safety
contours may be
changed with the
"Safety contour"
field in the Display
Settings. Select used
condition during
monitoring the same
as planned.
Differences between
used and planned
conditions are
displayed with
asterisks (*).
6. Setup Before Departure
6-5