Choosing Datum - Furuno FEA-2107 Operator's Manual

Copy from Monitored:
Copy monitored route to plan route.
Backup and Restore:
You can make a backup of a route to a floppy disk or restore a route from a floppy disk. See Chapter 17.
Report:
Generate report of planned route.
Full WP Report:
Generate detailed report of planned route.
Passage Plan Report:
Generate a combined report from active planned route and active pilot data.
Note: To display a planned route, make sure that desired options of the planned route (Center line, Channel borders,
WP marks, Leg marks, etc.) are chosen to either Std or Other on the Route page in the Chart Display dialog box. For
the procedure, see below.
Spin the thumbwheel to display Chart Display/Info/Standard
Display in the mouse functions area and then click the left mouse
button to open the Chart Display dialog box. Click the arrow tabs
or right mouse button to choose the Route page.
•
If all Planned route options are set to Std or Other, the text
"Displayed" is shown in the Plan Route dialog box.
•
If any Planned route option is set to Off, the text "Partly
Displayed" is shown in the Plan Route dialog box.
•
If all Planned route options are set to Off, the text "Not
Displayed" is shown in the Plan Route dialog box.
13.3

Choosing Datum

Selection of datum is very important, especially if you manually enter latitude-longitude positions or if you use a
digitizer. If you use the cursor to add and to modify waypoint locations, then you could use any datum, although it is
recommended to use native datum of the chart. For more information to choose datum, see paragraph 15.3
"Choosing Datum".
13. Route Planning
13-3