Adding A New Waypoint At The End Of A Route; Inserting A Waypoint - Furuno FEA-2107 Operator's Manual

13.5.4

Adding a new waypoint at the end of a route

There are two ways by which you can add a new waypoint at the end of a route:
•
Use the cursor and left mouse button to define position of a waypoint.
•
Use the Next WP button in the WP page.
To add a new waypoint by using the left mouse button, do the following:
1. Place the cursor on Route in the status bar and then click the Plan button to open the Plan Route dialog box.
Click the WP tab to open the WP page. Check Enable changes.
2. Place the cursor in the electronic chart area on the location desired for a waypoint and then push the left mouse
button. The waypoint is added at the end of route.
3. Modify data of added waypoint.
To add a new waypoint by the Next WP button, do the following:
1. Place the cursor on Route in the status bar and then click the Plan button to open the Plan Route dialog box.
Click the WP tab to open the WP page. Check Enable changes.
2. Choose last waypoint.
3. Click the Next WP button in the Waypoints page. Enter direction and distance for waypoint and then click the
OK button.
13.5.5

Inserting a waypoint

If you want to insert a waypoint between two waypoints, use the Insert before button, on the WP page. This inserts
a waypoint next to current waypoint. For example, you want insert a new waypoint between waypoints 6 and 7.
Choose WP 7 and then click the Insert before button. The new waypoint will be inserted between WP 6 and WP 7.
WP is highlighted on WP list.
13. Route Planning
13-11