Using The Parameters Page; Using The Prepare Page - Furuno FEA-2107 Operator's Manual

13.4.4

Using the parameters page

The Parameters page allows you to set departure time and arrival time for your route. Also optimisation type is
chosen in this page.
Enable changes:
Description:
ETD/UTC:
ETA/UTC:
Speed limit:
Income:
Optimize:
Optimizing your route
After all waypoints are inserted and you have made safe water calculation, you can optimize your route. If not
chosen, then optimisation will be done automatically with max. speed. If you want do optimization with specific
strategy, see paragraph 13.6.1 "Available route optimization strategies".
13.4.5

Using the prepare page

The Prepare page allows you to prepare for exchange of planned route with monitored route. Use this page if you
are going to use the exchange function to choose planned route as monitored route. If you do not use this page to
define To WP and Final WP for steering in the planning mode, ECDIS will choose the most suitable To WP based
on own ship position and Final WP based on waypoint selected on the Parameters page.
Check in order to enable editing.
Note: A route may only be modified when using the north-up or course-up
mode.
Enter note concerning the route.
Planned estimated time of departure from a specified waypoint. (0 is
automatically the first waypoint)
First part is planned estimated time of arrival to last waypoint. (0 is
automatically the last waypoint). ETA can be calculated between two specified
waypoints.
Second part is calculated ETA which may differ from planned ETA if it is
impossible for them to agree with chosen optimization method. Also total
length of the route is displayed.
Set speed limit for a route.
Budget for this voyage. ( Income * 1000$)
Optimize types are max. speed, timetable, max profit and min. cost.
(Description is provided in paragraph 13.6.1.)
13. Route Planning
13-7