Furuno FEA-2107 Operator's Manual page 285

Opening the user chart dialog box and menu
1. Place the cursor on UserChart on the status bar. Click either Plan or Monitor button to open corresponding
dialog box. If no User Chart has been chosen, one of the menus shown below appears, along with appropriate
dialog box.
2. Use the menu to choose user chart.
If you want to make further selection from a menu and only the dialog box is shown, you can show the menu on the
display by clicking the Plan or Monitor button again, or place the cursor on the triangle in the dialog box.
[User Chart]
Go Monitor mode
Select
Unselect
Create
Backup and Restore
Combine
Point report
Line report
Area report
Symbols report
Tidal report
Full report
Report for radar
Close
[User Chart]
Go Plan mode
Select
Unselect
Backup and Restore
Point report
Line report
Area report
Symbols report
Full report
Report for radar
Close
Point report:
Generates report about points in a user chart.
Line report:
Generates report about lines in a user chart.
Area report:
Generates report about area objects in a user chart.
Symbols report:
Generates report about symbols in a user chart.
Tidal report:
Generates report about tides in a user chart.
Full report:
Generates report about all the objects in a user chart.
Report for radar:
Generates report about all the objects in a user chart which are displayed on the radar screen.
Go Monitor(or Plan) mode:
The user can switch user chart mode between plan and monitoring modes
with Go Monitor(Plan) mode on the menu. Push the thumbwheel to show
the sub menu shown below.
Go Monitor mode>Go Monitor mode: User chart used in planning
mode can be switched directly to monitoring mode.
Go Plan mode>Go Plan mode: User chart used in monitoring mode can
be switched directly to planning mode.
Select:
User can specify user chart to use.
Unselect:
Remove current user chart from active use.
Create:
User can create a new user chart.
Backup and Restore:
User can make backup copy of user chart or restore user chart from
backup device.
Combine:
User can combine two or more user charts together.
15. User Chart Control
15-3