Furuno FEA-2107 Operator's Manual page 654

FURUNO
5 USER INTERFACE
5.1
Position calculation
5.2
Navigation planning
5.3
Navigation recording
5.4
Automatic navigation
5.5
Route monitoring
5.6
User chart
5.7
Pilot data
5.8 MOB (Man Overboard)
6 DATA INTERFACE
6.1 LAN adapter
Gyro
Speed log
Navigational E/S
Position sensor
Wind data
AIS
Radar/ARPA
Alarm output
6.2 B-adapter (option)
Gyro
Speed log
Alarm output
Analog sensors
7 POWER SUPPLY
7.1 Processor unit
7.2
Monitor unit
7.3
LAN adapter
7.4
B-adapter
8 ENVIRONMENTAL CONDITIONS
8.1 Ambient temperature
8.2 Relative humidity
8.3 Waterproofing
Monitor unit (panel)
Other units
8.4 Bearing vibration
Navigation by result of positioning found with external sensor
Dead reckoning with gyro and log
Highly accurate position with combination of gyro, log, external
sensor and Kalman filter
Planning by rhumb line, great circle
Route creation
Route data may be transferred to radar
Latest 12 hours of navigation data may be recorded
(Time, position, bearing, speed, etc.)
Trackpilot (option) required
Off-track display
Waypoint arrival alarm
Shallow depth alarm
User chart creation (2000 lines max. 1000 symbols max.)
User chart is overlaid on electronic map
User chart may be transferred to radar screen
Creation and display of pilot data
Pilot data may be transferred to radar (radar must be display)
Position and other data at time of man overboard are recorded
MOB mark is displayed on the screen
HDT (IEC 61162-1)
VBW (IEC 61162-1)
DBT, DPT (IEC 61162-1)
GLL, GGA, VTG, ZDA, DTM (IEC 61162-1)
MWV (IEC 61162-1)
ABM, BBM, etc. (IEC 61162-2)
Two units
3ch: relay contact (normal close)
sync/step
200p/m
8ch: relay contact (normal close)
8ch: Rudder, ROT, RPM, PITCH, etc.
100-230 VAC: 1.5-0.5A, 1 phase, 50-60Hz
100-230 VAC: 0.6-0.4A, 1 phase, 50-60Hz
24 VDC: 0.15A
24 VDC: 0.21A
-15°C to +55°C
95% at +40°C
IPX5
IPX0
IEC 60945
SP-2
FEA-2107
E4122S01D