Table of Contents
Advertisement
Repair procedures - SAN management application
6. The switch IP address resets to the default address of 10.1.1.10.
— If the configured IP address (prior to reset) was the same as the
default address, the browser-to-switch Internet connection is
not affected and the procedure is complete.
— If the configured IP address (prior to reset) was not the
same as the default address, the browser-to-switch Internet
connection drops and the EFCM Basic Edition session is lost.
Continue to the next step.
7. To change the switch IP address and restart the EFCM Basic
Edition interface, refer to
the EFCM Basic Edition interface using the default IP address of
10.1.1.10:
a. At the browser, enter the default IP address of 10.1.1.10 as the
Internet URL. The Enter Network Password dialog box displays.
b. Type the default user name and password.
NOTE: The default user name is Administrator and the default
password is password. The user name and password are
case-sensitive.
c. Click OK. The EFCM Basic Edition interface opens and the
procedure is complete.
The following procedures (performed at a rack-mount management
server running a SAN management application) are described. SAN
management applications include SANavigator 4.2 (or later) and
EFCM 8.7 (or later).
•
Obtain fabric and switch log information.
•
Perform port diagnostics and swap ports.
•
Collect maintenance data.
•
Set online state.
•
Block or unblock a port.
•
Upgrade firmware and software
•
Manage configuration data.
Configure network
information. To restart
Chapter 4: Repair information
173
Advertisement
Table of Contents
