Table of Contents
Advertisement
Figure 13
30
SAN32M-2 Installation and Service Manual
Parameters View
b. At the Rerouting Delay field, check (enable) or uncheck
(disable) the parameter. When enabled, traffic is delayed
through the fabric by the user-specified error detect time out
value (E_D_TOV). This delay ensures Fibre Channel frames
are delivered to their destination in order.
c. At the Domain RSCN field, check (enable) or uncheck (disable)
the parameter. When enabled, attached devices can register to
receive notification when other devices change state.
d. At the Suppress RSCN on Zone Set Activations field, check
(enable) or uncheck (disable) the parameter. When enabled,
RSCNs are not transmitted when a zone set is activated.
e. At the Limited Fabric RSCN field, check (enable) or uncheck
(disable) the parameter. When enabled, RSCNs are not
transmitted after a product initial program load (IPL).
f. At the Zone Flexpars: Isolate Fabric RSCNs on zone activation
changes field, check (enable) or uncheck (disable) the
parameter. When enabled, zone FlexPars isolate and prevent
fabric-format RSCNs from propagating to devices in zones
that are not impacted.
g. At the Preferred Domain ID field, type a value between 1
through 31. This value uniquely identifies each fabric element.
Advertisement
Table of Contents
