Table of Contents
Advertisement
110
SAN32M-2 Installation and Service Manual
•
AC power distribution for the product failed or AC power was
disconnected.
•
The product CTP card failed.
Continue to the next step.
3
Ensure the product is connected to facility power. Inspect the product
for indications of being powered on, such as:
•
An illuminated PWR LED (green) or ERR LED (amber).
•
Illuminated LEDs adjacent to Fibre Channel ports.
•
Noise and airflow from cooling fans.
Is the product powered on?
YES
NO
↓
A power distribution problem is indicated. Go to
Power distribution
4
A product-to-PC link problem (Internet too busy or IP address typed
incorrectly) or an Ethernet port failure is indicated.
a. Wait approximately five minutes, then attempt to login to the
product.
b. At the Netsite field (Netscape Navigator) or Address field
(Internet Explorer), type http://xxx.xxx.xxx.xxx, where
xxx.xxx.xxx.xxx is the product IP address obtained in
0000: Start
MAP. The Username and Password Required dialog
box appears.
c. Type the user name and password obtained in
MAP
and click OK. If the EFCM Basic Edition interface does not
open, wait five minutes and perform this step again.
Is the EFCM Basic Edition interface operational?
NO
YES
↓
The Internet connection is restored. Exit MAP.
Failure of the Ethernet port is indicated. Replace the switch.
Exit MAP.
analysis. Exit MAP.
MAP 0100:
MAP
MAP 0000: Start
Advertisement
Table of Contents
