Chapter 3: Maintenance analysis procedures
Factory defaults
Quick start
© Copyright IBM Corp. 2006
This chapter describes maintenance analysis procedures (MAPs) used
by service representatives to fault isolate switch problems or failures .
MAPs consist of step-by-step procedures that provide information to
interpret system events, isolate a failure to a single part, remove and
replace the failed part, and verify product operation.
Table 5
lists factory defaults for product passwords (customer and
maintenance level), and the product's Internet Protocol (IP) address,
subnet mask, and gateway address.
Table 5
Factory-set defaults
Item
Customer password
Maintenance password
IP address
Subnet mask
Gateway address
Table 6
lists and summarizes MAPs. Fault isolation normally begins
at
MAP 0000: Start
MAP.
MAP summary
Table 6
MAP
MAP 0000: Start MAP
MAP 0100: Power distribution analysis
MAP 0200: POST failure analysis
Default
password
level-2
10.1.1.10
255.0.0.0
0.0.0.0
Page
100
105
107
95