Table of Contents
Advertisement
Event code: 081 (continued)
Event Data
B = Unresponsive node - The attached node did not respond, resulting in a G_Port ELP timeout. Check the
(continued):
status of the attached device and clean the link's fiber-optic components (cable and connectors). If the problem
persists, contact support personnel to report the problem.
C = ESA security mismatch - Processing of the Exchange Security Attribute (ESA) frame detected a security
feature mismatch. The switch binding parameters for this switch and the attached fabric element must agree. At
the Switch Binding - State Change dialog boxes, ensure the parameters for both fabric elements are compatible,
or disable the fabric and switch binding features.
D = Fabric binding mismatch - Fabric binding is enabled and an attached fabric element has an incompatible
fabric membership list. At the Fabric Binding dialog box, update the fabric membership list for both fabric
elements to ensure compatibility, or disable the fabric binding feature.
E = Authorization failure reject - The fabric element connected to the switch through an ISL detected a security
violation. As a result, the switch received a generic reason code and set the port to an invalid attachment state.
Check the port status of the attached fabric element and clean the link's fiber-optic components (cable and
connectors). If the problem persists, contact support personnel to report the problem.
F = Unauthorized switch binding WWN - Switch binding is enabled and an attached device or fabric element
has an incompatible switch membership list. At the Switch Binding - Membership List dialog box, update the
switch membership list for the switch and the attached device or fabric element to ensure compatibility, or disable
the switch binding feature.
10 = Authentication failure - An ISL challenge handshake authentication protocol (CHAP) check failed. Update
the authentication list or disable the authentication feature.
11 = Fabric mode mismatch - Based on the ELP revision level, a connection was not allowed because an IBM
switch in legacy mode is attached to an IBM switch in Open Fabric mode, or an IBM switch in Open Fabric mode
is attached to an OEM switch at an incorrect ELP revision level. Update the fabric mode for one switch using the
Interop Mode drop-down list at the Configure Fabric Parameters dialog box.
12 = CNT WAN extension mode mismatch - Based on switch-to-switch differences between the ELP maximum
frame sizes allowed, a connection was not allowed to a switch set to Computer Network Technologies (CNT) wide
area network (WAN) extension mode. Contact support personnel to obtain software maintenance release
4.02.00. This release is required to correct the problem and allow switches to communicate with CNT UltraEdge
WAN Gateways.
Distribution:
Product
EFCM Basic
Event Log
230
SAN32M-2 Installation and Service Manual
Management Server
System
Event Log
Error LED
E-Mail
Call-Home
Sense Info
Host
Link Incident
Log
Advertisement
Table of Contents
